Core One L roof rack brace for Creality Space Pi X4
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Core One L roof rack attachable brace for the Creality Space Pi X4
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 51
- Makes
- 0
- Views
- 742
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A pair of braces for the Core One L roof rack to place the Creality Space Pi X4 filament dryer.
Printing
Material: PC recommended for structural strength and heat resistance.
Nozzle: 0.4mm
Layer height: 0.2mm structural
Infill: 15% gyroid or whatever
Perimeters: 3
Solid layers: 5 top, 4 bottom
Brim: 8mm wide with default 0.1 separation gap. Without brim the will likely significant warping.
Supports: add supports so the cutout for the roof rack is supported
Bill of materials
Printed parts:
COL-roof-rack--accessory--space-pi-x4.stlcontains both braces needed.Non-printed parts: 4x M3x16mm socket screws to attach braces to roof rack, they replace 4x M3x12mm of the roof rack BoM.
Assembly
Remove brims and supports.
Remove the 4 M3x12mm from the roof rack top, if you assembled it, the 2nd most from the outer edge.
Align the braces with the screw holes of the roof rack, screw holes should be nearer to the center. Refer to the photos if needed.
Attach the braces with the M3 screws.
Place the roof rack on the Core One L, place the Space Pi X4 on the roof rack braces, make sure that everything seats nicely, it's a snug fit.
Consider leaving a make and sharing your roof rack adventures. A like is appreciated if you got some use out of this model.
OpenSCAD
Requires the BOSL2 library.
Changelog
2026-04-25: v0.2.0: updated to HSW compatible spacing
2026-04-17: v0.1.0: initial version