Desk-Edge Cable Clamp — Clip-On with Printable Thumbscrew
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A C-clamp that grips the edge of any desk and carries a cable through a C-shaped snap-in hook. Held in place by a fully
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 85
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
A clip-on desk-edge cable clamp that routes one cable through a C-shaped hook on the side. No metal parts, no tools — the whole thing is three printed pieces.
Prints:
cable_holder_body.stl— the C-frame with the threaded hole and side cable hook (the blue body in the photos).cable_holder_screw.stl— knurled thumbscrew with a fully printable trapezoidal thread (the red knob).cable_holder_pad.stl— small swivel cap that snaps onto the screw tip so it doesn't bite the table underside.
Fits desk tops up to about 55 mm thick. Snap a cable into the C-hook from the side; the inner curl keeps it from popping back out.
Print the body on its side (bore horizontal), the screw knob-down, the pad flat. PLA or PETG, 0.2 mm layers, 3 walls, no supports. Screw the thumbscrew up into the body until it clamps firmly against the underside of the desk.