modular, customisable model rocket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Share Alike
DISCLAIMER!:
this is the prototype version and does not have a large selection of parts, the v2 will have a payload fairing, upper stage and payload section.
this is a 99 percent 3d printed model rocket that is inspired by Kerbal space program, it can use:
.any 12+ inch parachute
.b6.6 to c6.5 estes model rocketry engines
.a standard estes (rod type) launch stand
REQUIREMENTS:
.print in PLA because it does not shatter like PETG
.must have 3 walls and gyroid infill
.print the fin can with 30% infill
if there are any problems or suggestions, leave a comment and I will read them every week
ALSO: in the print files there is a part for helping to glue up the body tubes.