1 / 1
peony flower HueForge
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I created an peony flower HueForge.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 38
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print with 100% infill and a layer height of 0.08mm. The base layer should be 0.16mm.
Swap procedure: Initial filament: Black
Switch to the next filament at layer #8 (0.72mm): Lipstick Red
Switch to the next filament at layer #12 (1.04mm): Yellow
Switch to the next filament at layer #20 (1.68mm): Green
Switch to the next filament at layer #21 (1.76mm): White (Use until the final layer)