Gasmask Inlet-Cap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gasmask Inlet-Cap with Nato RD40x1/7 thread.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 30
- Makes
- 0
- Views
- 87
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Costume Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Gasmask Inlet-Cap with Nato RD40x1/7 thread.
Inspired by Jan Asleep's model “NATO 40mm Gas Mask Inlet Carb”
However, Jan Asleep's model was still too wide for my taste, so I scaled it down a bit.
I also made the threaded section slightly longer.
Outer diameter: ca. ~ 48 mm
Total height: ca. ~ 22 mm
Height of threaded section: ca. ~ 15 mm
The caps have lots of small holes on the sides so that air can continue to circulate freely.
There are three versions: plain, with the “radioactive” logo, and with the “hazmat” logo.
print with face down (also the ones with logo)
0,2mm layerhigh
without brim
without support
3 perimeters
100% infill (for best stability)
Use at your own risk! Not for commercial use!
see also my other Gasmask-Adaptor's :-)
https://www.printables.com/model/1693950-gasmask-adaptor-nato-rd40-male
https://www.printables.com/model/1694022-gasmask-adaptor-nato-rd40-male-90-degree
https://www.printables.com/model/1693962-gasmask-adaptor-nato-rd40-female