Hush - HPA Rush

THIS GUY ACTUALLY MADE THE THING, GO SUPPORT HIM NOT ME - https://www.printables.com/@AMSPawn06_2126731

This is a remix of the Rush that rips out the springer internals and replaces them with a HPA Core. I've only uploaded the changed files, but you'll also need the top rails, mag catch and release.

BOM:

• 3x M3 Threaded Rods

• 6x M3 Nuts

• 2x M3x25mm screws

• 1x M3x20mm screw

• 16x M3x8mm screws

• 1x Mag release Spring

• 1x DMRCore (Snipercore also works but is infinitely less reliable in experience)

• 1x Worker Barrel cut down to about 200mm

• 1x MJ0V3 Valve

• 2x Small form factor Right Angle Macroline to NPT adaptors

  • I used these which are a tight fit, though this is for a BSPP valve so you'll need to source your own unfortunately - https://www.allthedarts.co.uk/shop/p/ggnvsx5auw2bnmbivoe5rjxivq8lhz

• 1x Macroline to NPT Fitting

• 1x 6mm Macroline to male NPT fitting

• 1x Female NPT to Quick Disconnect fitting

  • You can replace the above 2 with a single fitting, I just like having the QD solidly attached to the blaster - https://highpressureairsoft.co.uk/collections/fittings/products/balystik-male-nipple-for-macroline-us-version

• Some 6mm Macroline or similar tubing

Assembly is the same as the standard rush, but the brass collar for the cores drops in between the front of the upper reciever and the rear of the shroud and is held in place by the shroud. Barrels just screw in through the front. Core is held in place between the front of the reciever and the rear blaster cap. Also the bottom rail is a snap fit.

Please comment if you have issues I suck at this.