Bunkerotter's SVRN Upgrade Parts

This is a repository of slightly adjusted, tweaked and additional Parts like a weapon lock, silicone cast wheels, and possible others for the modular Antweight Combat bot "SVRN" by Shoverrobotics

Everything is compatible with the original SVRN Bot, unless specifically noted.

List of parts and instructions (not yet complete, as some of the parts are still WIP and subject to change):

Modified Parts

• SV11BO BASE PANEL

  • Slightly thinner base panel, and closed off at the bottom to prevent ingesting debris in to the gearboxes.

  • Slightly increased counter sunk screw holes to make them flush with the panel.

• SV01BO CHASSIS

  •  Modified to accept Botbitz' Screw Switch V5 Short and a 3mm Power LED, which is required by some Tournaments.

• SV09BO SIDE PANEL RH

  • Part of the front wheel well had a bigger radius and therefore had less clearance to the wheels compared to the other armour packages. I streamlined that so that it's in line with the other armour parts.

• EV05BO2 FLIPPER MOUNT (KINGMAX C507)

  • Adjusted fit for the Servo, specifically the small metal tabs. Might be just my badge of C507 servos, but the tabs were slightly longer then in the CAD model by Shoverrobotics. I've also added slightly longer tabs on the top, to hold the Servo in place. Not sure if needed \_(ツ)_/

  • Shifted the Servo slightly, to be able to use Aluminium Servo Arms

• SV06BO WHEEL

  • Redesigned 3mm D-Shaft hole for better fitment.

New Parts

• BO-01 WEAPON LOCK

  • Some Tournaments require active weapons to be locked outside of the arena, even for flippers and grabbers. Print it with TPU, 2 Perimeters and no infill to make it a bit flexible. A quick explanation on how to use it:

    

    To take it out, just do the same move in reverse.

Silicone Cast Wheels

• BO-02 HUB

  • Print in PLA-ST, with just perimeters (set it to 10 or so), no support, at 0.1mm layer height. Print orientation should be with the D-Shaft hole on the bed. Some slight clean up is required, as the overhangs will produce 1-2 strings to detach. This can be somewhat improved with manually painting the seamlines on the inner barrel.

  • More detailed instructions will follow, if I don't forget it ;)

• BO-03 MOULD LID

  • Print in normal PLA, default settings

  • More detailed instructions will follow, if I don't forget it ;)

• BO-04A MOULD A

  • Print in normal PLA, default settings

  • More detailed instructions will follow, if I don't forget it ;)

• BO-04B MOULD B

  • Print in normal PLA, default settings

  • More detailed instructions will follow, if I don't forget it ;)