MAX4410 amplifier boards enclosures

Small enclosure boxes for MAX4410 headphone amplifier boards, which you can get for cheap from Aliexpress.

The lid is designed to be snap fit and can be closed relatively easy, but for opening it you may need to help yourself with something to apply some force since it turned out to be pretty tight, but can be taken out without much effort. For keeping the board itself in place I made some 3mm holes to fit M3x10 screws that I had laying around, though it could be virtually any length of M3 screws up to 10mm.

Designed mainly to be placed inside a beatmania IIDX cabinet. Also made a double version to fit two boards inside which served my purpose better and should waste less material.

Can be perfectly powered up with a 12V 1A power supply, or atleast the ones I got allow for 12V. In my case I used a solderless DC male connector to draw power directly from the PSU inside the cabinet's PC. For soldering each component I used AWG 22 wire but for the audio jacks a smaller gauge could be used.

Materials used:

• MAX4410 amp boards

• M3x10 screws

• DC022B 2.1 x 5.5mm DC Power Jack Female

• DC Male Terminal Connector 2pin DC Power Adapter 2.1 x 5.5mm

• PJ392A Female 3-pin Audio Jack 3.5mm

• XH2.54 JST 3-pin and 2-pin connectors (kit with connectors and terminals)