Bento Box Air Filter for 120mm Fan - HEPA + Carbon Trays
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Similar to other bento box filters with HEPA and activate carbon trays but sized for a 120mm PC case fan.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 25
- Makes
- 1
- Views
- 308
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to have a bento box air filter for my ABS prints inside my Prusa Mini's Lack enclosure that used a PC case fan rather than the smaller ones I found elsewhere. This is my first version of the design, and I am sure it could be improved, so remixes are welcome.
Printed with PLA and sections are slotted together with guides between each section. I used foam weatherstrip tape under the HEPA filters to prevent air from flowing around it.
List of materials and instructions below.
Materials (not affiliated):
Fan: https://www.amazon.com/dp/B0DJDC74BP
Fan Controller: https://www.amazon.com/dp/B0FPCTW57S
Fan Controller Power Cord: The fan controller listed can use a USB type C, so you may not need to purchase a power cable if you have one laying around. Just make sure that it is 12V so you can use the full capabilities of the fan.
HEPA Filters: https://www.amazon.com/dp/B00K7DMEJ0
Activated Carbon: https://www.amazon.com/dp/B0CFY14DZZ
Weatherstrip Tape: https://www.walmart.com/ip/Duck-Brand-Black-Foam-Weatherstrip-Seal-0-375-in-x-0-188-in-x-30-ft-2-Pack/932077255
Instructions:
The preferred order of the sections is intake -> carbon -> hepa -> fan. The sections should slot together well. If you print the intake in two parts with the poles separate, glue the poles to the main intake housing. Sealing the internal connection lines between sections can help improve airflow, but ensure seal is not permanent so that you can change out the carbon and hepa filters as needed.
Fill the carbon tray with active carbon pellets so they are spread even about 15-20mm deep. Do not pack tightly.
Place the weatherstrip foam around the inside bottom of the hepa housing so that the hepa filters can rest of them to prevent air from flowing around the filters rather than through them. Ensure that the hepa filters are oriented in the correct direction so that the dirty air is entering on the correct side.
The fan fits snug into the fan housing, so I did not use any screws to seat it in the print.
Plug the fan into the fan controller. I used an old iPhone charging cable to power the fan controller, so I did not need to purchase this.