CPAP Mask and Hose holder - Clamp on to Curved Bed Frame
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bracket that attaches to a curved bed frame to hold your CPAP mask/hose
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 15
- Makes
- 0
- Views
- 173
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Share Alike
This changes the most recent version of the top link from 35mm wide bed trim to handle a 55mm wide bed edge.
I added a retention screw hole and created a screw that pins one side of this bracket to the bed frame edge and a 3D printed bolt that does the compression work against the wood edge to pin the bracket on the bed frame.
I tapped the bearing retention pin and added a pad with a hole so now the hose clamp pins the bearing from the top and it's retained into the shelf created by the most recent remix using an M3x8 or 10 pan head screw (flat top would be even better and the pad is chamfered for one).
The only original part left is the hose clamp, which is sized correctly for the 'smaller' mask tubing used on most (certainly Respironics) terminal tubing that the 'mask/nasal pillows' etc. attach to.
I printed in PETG so it would have some flexing to make attaching to the bed frame a little more solid. I used .2 layers, 15% infill, 4 walls, 3 top and bottom surfaces and no supports. I would think PLA or any other material (no CF material as it's rough and might damage your wood) should work fine - the hose and mask combos are very light.
Feel free to remix as you need and let me know if you need a different width and lack the experience to make that modification. Hope it helps!
