1 / 8
Tower Hobbies P-51 Mustang Retract Shim and Gear Cover Clip — image 1
1 / 8

Tower Hobbies P-51 Mustang Retract Shim and Gear Cover Clip

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

New models (2017 and on) of the Tower Hobbies P-51 Mustang RC plane have an option for retractable landing gear…

Rating
0 / 5
Likes
0
Downloads
3
Makes
1
Views
26
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

New models (2017 and on) of the Tower Hobbies P-51 Mustang RC plane have an option for retractable landing gear (retracts), which is awesome. Unfortunately, with the gear in the default location, the plane has a tendency to nose-over on landing, particularly on grass. (The Tower P-51 Mustang has always been this way, it's nothing new.)

If you use the non-retractable landing gear, you can simply bend it forward a bit to improve your chances of a proper landing. With the retracts, you can't do that (since the gear will not retract correctly into the wing). Instead, the solution is to put shims under the retract mounting. That causes the retract to rotate slightly, so it raises the gear slightly forward from the default.

These shims will rotate the gear about 3 degrees, which moves the wheel forward about 1/4". I have a shim for both the front and the back side, with an angle built-in on both pieces. The stock screws seem to be long enough to hold it in place with the shims, but slightly longer screws might be better.

Additionally, I made a "clip" part that allows you to use the gear cover that comes with the plane (for the static landing gear) with the retracts as well. The wire on the retracts is slightly larger diameter (3mm) so my clip is 3mm.

The shims are thin, so print with a fairly high resolution (like 0.12). It only takes a few minutes to print them. To make sure your slicer prints the thinnest edge, have your initial layer no bigger than 0.3. I used PLA.

Tags