Folding Ruler Marking Gauge
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My version of the marking gauge for folding rulers common in Europe - original design by MrFuzzy_F on Thingiverse
- Rating
- 4.923 / 5
- Likes
- 71
- Downloads
- 545
- Makes
- 13
- Views
- 1,817
- Reviews
- 13
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
My version of this practical marking gauge, designed for folding rulers common in Europe. I made some modifications in the OpenSCAD file to better fit these rulers and to remedy some printing problems I had with the initial version.
Original work by MrFuzzy_F on Thingiverse, distributed under CC BY-NC.
https://www.thingiverse.com/thing:3514928
Visit his Thingiverse page for many other pre-made models and the original OpenSCAD file without my mods.
My first one was printed in PLA and broke at the lever. So I now print in PETG, 0.6 mm nozzle with four perimeters and four tops/bottoms. Minimal supports required, but on build plate only. Print with a layer height of 0,2 mm - otherwise, the “print-in-place gap” for the lever hinge might turn out too small and the lever will be welded in place.