Ramp for Extrutim's drybox
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple ramp to elevate the front of the drybox, to let the filament exit easier.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 102
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
it is pretty strait forward, its merely a ramp for the drybox.
although it has some things worth metioning.
there are 4x indents on the bottom that fit these rubber bumpers from home depot: https://www.homedepot.com/p/Everbilt-3-8-in-Clear-Self-Adhesive-Round-Bumper-16-Pack-41-H1006/328914125
(these are also great for the bottom of the dryboxes themselves
and the 6 cylinders coming out of the model are object modifiers, meant to reduce the amount of bridging material, if you load it into your slicer the cylinders should disappear except for small rings that you can see on the surface of the item.
My print settings for this item are:
layer height: 0.2
sparce infill density: 2%
wall loops: 2
settings for the cylinder modifiers:
1% infill
1 wall loop
total material used was (for me): 80.4 grams (pla)
Time taken to print (again for me) 2H53M (173 minutes)
I hope this will help someone, feel free to edit my design!
(made on Tinkercad)