LED Matrix enclosure for 1, 2 or 3 Waveshare LED matrix panels.

I found a LED matrix project on Youtube by Chuck Builds, and designed 4 types of enclosures to fit 1, 2 or 3 Waveshare LED Matrix panels. 

The main enclosure files consist of 

1. LED matrix enclosure Main body left

2. LED matrix enclosure Main body middle

3. LED matrix enclosure Main body right 

4. LED matrix enclosure Main body (1 panel version)

The Hardware and software i used for this project is created by Chuck Builds. 

Big thanks to Chuck Builds for a great project and Tutorial :-)

(See links below)

Info.

The enclosures are designed specific for the following parts:

• Waveshare RGB-Matrix-P2.5-96x48-F

• Raspberry Pi3

• Adafruit Triple LED Matrix Bonnet for Raspberry Pi

There is a hole on the back, to press fit the separate 2.5 mm Plug that was supplied with the LED matrix panels

Printing info.

The parts were designed for Prusa MK4S This means that the individual parts will fit within the print Area (X×Y×Z): 250×210×220 mm.

Prusa Slicer settings:

Filament = PLA or PETG

Infill =15% or more

Brim = Yes (Brim width max. = 4 mm.)

Support = Yes

Perimeters = 2 or 3

Assembly info.

Assemble the enclosure with the top and bottom plates

(Use SuperGlue)

Insert 48 x Magnets 10x3mm

(Use SuperGlue)

Use the 4 assembly guides to align the two enclosure parts. By inserting these into the 4 slots.

(Use SuperGlue = optional)

Use the 2 Assembly locks to lock the two enclosure parts together.

(Use SuperGlue = optional)

Install the Raspberry Pi

(Use 4 x 2.5 mm screws)

For further Hardware and software info. Please see the info. From Chuck Builds.

(See links)

Links:

Chuck Builds webpage:

https://www.chuck-builds.com/led-matrix/?__cf_chl_tk=mdwTDKTCgN37he479_D_qzmuCGnFt2BPbgVR3AzKe.w-1776953899-1.0.1.1-2Y4XC1UsJ5DfbgTZZFYGJR28lNwBQ_AYFzW25xvoHUM

Chuck Builds on YouTube:

LEDMatrix Install Tutorial | Full Setup

Chuck Builds on Github:

https://github.com/ChuckBuilds/LEDMatrix