Blink Outdoor 4 Camera Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Just a flat surface type stand for the Blink 4 Outdoor camera
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 30
- Makes
- 0
- Views
- 139
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
So I keep this camera in my garage, sitting on top of the water heater. The normal stand plus right-angle adapter doesn't quite allow it to angle down and still sit properly, especially with the extended battery pack. Plus whenever it is moved to replace batteries, it's difficult to get back in the exact same position misaligning any defined detection zones. So I made this (using Tinkercad)!
May be suitable for other cameras with similar sized bases.
Just using the standard base without the angle adapter, the base slides down from the top into the stand, allowing full range of motion. I'm going to mount it in place with 2-sided tape so it stays placed. Simply slide it out when needed.
I used PETG, any filament should be fine, as long as it is suitable for the intended environment. No supports needed. Just used standard infill/wall settings.