1 / 1
Enoshima(KANAGAWA) HueForge
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I created an autumn Enoshima using HueForge.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 20
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print with 100% infill and a layer height of 0.08mm. The base layer should be 0.16mm.
Swap procedure: Initial filament: Black
Switch to the next filament at layer #10 (0.88mm): Gray
Switch to the next filament at layer #15 (1.28mm): Cyan
Switch to the next filament at layer #18 (1.52mm): White (use until the final layer)