Lenovo Tiny Mini Rack mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mini rack mount for Lenovo Tiny 1L PCs, printable on 180x180 3D printers
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 244
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Everyone is talking about mini racks, and how nice and small they are but then they use big bulky printers to print mounts for they're hardware. I bought my mini racks to due to limited space and the easy with which I can transport it to a new place if I ever have to move, and for the same reason I bought an A1 Mini.
I couldn't find many good options for a mount that you could print out on a smaller machine (I haven't really looked), so I decided to make my own! This model is for the MX10 generation of Lenovo Tinys (such as M710 or M910), but it may fit other ones as well.
Printed with PLA, as I have a suspicion it will be just fine. Make sure to crank the wall loop count for strength (I used 6 for mine, and it was pretty much a solid piece). You will need 8 M3x8 screws that are not counter-sunk, and 8x M3 nuts.
NOTE: I had to make some last minute changes to the model to generate the Ear without the keystone jack. As such, that single model should fit, but I haven't tested it. If that's the case, let me know by leaving a comment.