Banana Pi BPi-R3 buttons for official case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small piece to make the BPi-R3 buttons usable without tools on the official metal case. Has a flap to glue it in place.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
The official metal case for the Banana Pi BPi-R3 router board only provides small holes for the WPS and reset buttons, which are therefore impossible to press without tools. This small piece fits between the buttons and the case, providing two small shafts that protrude just enough so that you can press them comfortably with your fingers.
The tab extending from the strip for the buttons is supposed to be glued onto the inside of the lid to keep it in place when opening the case. It's not strictly needed, but the strip has a hard time staying in place without the buttons keeping it there, which makes assembling the case very annoying.
Small reminder: These button holes are tiny, as a result this piece is very small as well. I recommend printing with 0.2mm layer height and sticking to a well calibrated filament that prints cleanly.