ZOHD Talon GT - Walksnail GT2 Nose Cone
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Nose Cone Mod for ZOHD Talon GT (Walksnail Avatar GT2 Setup)
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 5
- Makes
- 0
- Views
- 69
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Nose Cone Mod for ZOHD Talon GT (Walksnail Avatar GT2 Setup)
The mod houses the Avatar GT2 VTX aswell as a 9g Servo to allow a tilt motion while flying.
This guide explains how to install a Walksnail Avatar GT2 VTX and camera into the custom 3D-printed nose cone for the ZOHD Talon GT.
🔧 Required Tools & Parts
Sharp knife
2× M3 heat inserts
2× M3 × 10 screws
2x M6 x 4 screws
Hot glue
✂ Step 1: Remove the Original Mount
Carefully remove the stock mounting adapter ring from the nose.
If the glue is weak, it should come off easily.
If not, gently pry it loose to avoid damaging the foam.
✂ Step 2: Trim the Foam Nose
Cut back the foam so that approximately 35 mm remains to the front hatch edge.
Remove small sections on both the left and right sides to make space for the mounting ring’s heat inserts.
🔩 Step 3: Install the Mounting Ring
Insert the M3 heat inserts into the mounting ring.
Use hot glue to securely attach the ring to the foam nose.
Ensure it is centered and aligned before the glue sets.
📷 Step 4: Install the Camera & VTX
Detach the camera from the VTX.
Route the V, G, TX, RX aswell as the camera cable through the nose opening.
Re-attach the Camera cable to the vtx.
Mount the VTX with 4x M2 Screws from the bottom.
Mount the Cage to the Servo and attach the servo horn. (make sure the servo is already in the right position.)
Insert the Camera in the Cage and screw it ion place with 2x M2 screws.
Mount the servo and screw it in place with the 2x Servo screws.
Screw the nose cone onto the mounting adapter with 2x M3 screws.
📡 Step 5: Antenna Placement
The antennas are held in place by pressure between the nose cone and mounting adapter.
This design allows easy removal for transport and is firm enough during flight.
🧩 Additional Components (from STL files)
Camera Cage
Designed to hold a short servo arm on the inner side.
