Hotbed cable chain Anycubic Mega S
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
cable chain to prevent breaking wires due to constant yanking
- Rating
- 4.75 / 5
- Likes
- 83
- Downloads
- 476
- Makes
- 3
- Views
- 2,323
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Anycubic Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
As I feared that the hotbed cable may break over time due to constant sharp bending I searched for a solution and ended up here: https://www.thingiverse.com/thing:4318284. I really liked the chain design but not that I would have to rotate the bed 90°, that actually was a no-go to me. That's why I ended up modifying the attachment to a style like shown in https://www.thingiverse.com/thing:4253211. The STL files are added here. The chain-links and springs are 100% original and you need 14 of them.
Print parameters: layer height 0.2mm, 50% Cubic Infill with 2 lines and support where needed. I printed with PLA but PETG or ABS/ASA might be better.
The hotbed bracket is attached with the rear 2 screws holding the rear bearing. The chassis bracket can be attached with two M3 screws and nuts or a wire tie or two 3,9mm sheet metal screws.
2022-05-05 Was made aware that I uploaded the wrong file for chassis-bracket. Was the one I started the remix from. Now the correct one is uploaded. Sorry!