1 / 2
FYSETC H36 mount ring for Orbiter 2 & 2.5 — image 1
1 / 2

FYSETC H36 mount ring for Orbiter 2 & 2.5

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Ring for mounting the FYSETC H36 Combo board on an Orbiter 2.5 or 2.0 extruder.

Rating
0 / 5
Likes
6
Downloads
43
Makes
0
Views
160
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Introduction

There are not many mounts out there for the FYSETC H36 board, so I had to come up with my own. I'm using Orbiter 2.5 extruders on DragonBurners for my toolchanger. This ring will fit v2.0 & v2.5 Orbiters.

Printing

Use standard Voron print settings with a heat resistant filament. The ring sits close to the extruder motor which can get quite hot. I used ABS which works fine for me.
For printing orientation I prefer to have the 'extruder-side' on the buildplate. This gives me the best looking result while only needing one support.

BOM

4x heat set insert M3x5x4
2x BHCS M3x20
2x SHCS M3x20 You only need these if the stock SHCS's on the Orbiter are too short

Tags