NG CoreXY

I had a tough time finding any proper integration for the Micro Swiss NG adaption to the CoreXY so I went on and made my own, this version allows for full X usage and allows you to use all the EVE3 Mods on their website. my main reason was using the Beacon probe which I can't afford yet but will be obtaining eventually.

I will be thinking of adding a filament sensor/cutter or a tool changer mod for the NG since this is advertised and I saw a good review on the extruder being the lightest in the market I hope to unlock its full capabilities.

They have a right and left mounted extruder mounts available which makes it perfect for a dual extruder build as well so there's definitely a couple options available, my only caveat with them is their standard direct drive doesn't come  with a motor were the NG does and its a 50 dollar difference plus the Revo version does not clog or leak like the standard block heaters.

The heater is downgraded from the stock 60W to a 40W heater, I've sourced one on amazon to gain some extra volumetric speed (higher flow)

BL touch probe bracket needed six washers so it wouldn't keep crashing my bed or claiming it was too high

use 4 M3x40 screws to secure the back of the bracket, the 45 are fine but will extrude a bit, doesn't interfere with the bracket but the shorter ones would fit best.

I've added my printer.cfg config this contains my maximum accelerations of 30k and 800 speeds, I've learned that these speeds are not possible to print with a current volumetric rate of 20 so im doing a couple tweaks to learn the maximum speeds and rates for this current extruder and will update so we can have an easier time setting these up