ECAS triple splitter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed a triple splitter, had ECAS connectors - made a remix.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 3
- Makes
- 0
- Views
- 62
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
As my previous 2-channel filament splitter broke and I also needed to run filament from external dryer, I made this remix to fit my personal rig - Voron Trident with 4040/20 cornerposts so it has extra room behind the XY rear horisontal 2020 frame. Splitter is spaced far enough to fit in there even with some insulation and to not rub against the belts. ECAS connectors are a really snug fit, remove all plastic and rubber parts before installation. If need be, drill the exhaust part of the splitter with 2mm drillbit if there's plastic sagging. Also good advice would be to flare out the telfon tube end that goes towards the toolhead so even more rigid filaments would not get caught by the sharper edge of the tube.
Mounts with single M4x10 bolt.