Chain Tensioner - Fiskar Momentum Reel Mower
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Chain tensioner for the Fiskar Momentum Reel Mower with Shimano derailleur
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 93
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
In action:
Summary:
After receiving no love from Fiskars warranty, I came up with this chain tensioner to continue using my half worn chain. I also cleaned and hot waxed the chain. But that's for another time.
Features
Alignment with chain can be adjusted simply by tightening/loosening spring securing screw
Design can be easily altered to fit various screws, and sprocket sizes.
Adjusting design to fit other spring sizes will be a bit tricker because the mounting point and the lip that holds the "tensioner adapter" does not change.
Additional parts needed:
spring from bike derailleur (I used a Shimano Atlus)
sprocket from bike derailleur
1/4"-UNC screw or similar to hold together spring. Use other screw size if you want, you just need to fill in the hole and put in another hole size either in IRL or digitally
Key notes to use existing design:
Hole for the screw that holds the spring is 5.8mm in diameter and 26mm deep. I suggest using a screw that is much shorter (ie <20mm long) so you can adjust sprocket alignment
The spring OD must fit within a 19mm diameter and fits over a 13mm shaft. The spring I use steps down to a smaller diameter. Which is why there a 10mm ID x 16.2mm OD section for the spring
The sprocket had a 38.2mm diameter. There were plenty of play in the bearing which was the reason for the extra clearance
The hole for securing the sprocket has a 4.3mm diameter for threads and a 5.5mm for clearance
Holes were sized so that the threads will be cut by the fasteners themselves.
Other Considerations:
don't be afraid to use a drill to alter the holes sizes if the fit is close.
Use a torch or heatgun to stretch out the "sprocket mount to get more clearance for the sprocket if necessary.
Printed with
3 walls
0.32 layer height
5 top layers
4 bottom layers
15% infill
random seam