[2-PIN] Improved Koss KSC75 2-PIN mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Same design as the MMCX version. This one is low profile, tries not to limit tilt as much as other designs.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 100
- Makes
- 1
- Views
- 606
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution
I got requests to made a 0.78mm version of the same design, so here you go. It's tested and works well.
Check out this flower grill:
Make
I printed on Prusa Mini with 0.25mm nozzle and 0.07mm layer height, 100% infill with Devil Design PLA.
Print with organic supports.
Parts and supplies needed
2x M2(.3 might work better) self tapping 4-6mm screw with flat bottom. Like the ones found in plastic housings.
https://nl.aliexpress.com/item/1005005264316197.html2x printed parts. choose the design you like 😀 L/R/heart/no marking or something you want yourself. files are there!!
Glue (I use two component glue)
2x 2-pin connectors (if you can find them pre-wired, that would be great)
https://nl.aliexpress.com/item/1005003354903218.html2x short pieces of headphone wire. I cut it from broken headphone wire, but you can use these as well:
https://nl.aliexpress.com/item/1005004026757882.html
How to
print parts
remove supports, and with a small knife, remove any pieces in the opening that are left of the supports
prepare the 2-pin connector with wires (solder)
glue the 2-pin connector to the part
wait for glue to harden
solder to driver
close with screws
enjoy