MandalorianSkull Start/Stop Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
0.1mm layer, 2mm Brim & 30% support, 15% infill. Run printer a little slower(85%) Props to funerall for model 3671177…
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 24
- Makes
- 0
- Views
- 202
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
0.1mm layer, 2mm Brim & 30% support, 15% infill. Run printer a little slower(85%) Props to funerall for model 3671177
File and Prints of models not to sell or resale
Print Settings
Printer:
gMax Xt+
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
15%
Filament:
JMO Technology PLA
Red
Notes:
A new filament and not happy with it. Another filament would work better. Printed 0.1mm layer w/ a 2mm brim, 30% support & 15% infill. Slow your printer down to about 85% feed rate. I used a paper clip heated to open the hinge holes, then cut a piece of the clip to use as the pin. Last, use thin double sided tape applied to the back of the ring & trimmed accordingly.
Category: Automotive