Zelda Shield
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
First I want to give props to fasteddy516 for the inspiration. File and Prints of models not to sell or resale This was…
- Rating
- 0 / 5
- Likes
- 298
- Downloads
- 696
- Makes
- 0
- Views
- 6,049
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Cosplay & Costumes in general
- License
- Creative Commons — Attribution — Share Alike
First I want to give props to fasteddy516 for the design.
File and Prints of models not to sell or resale
This was enlarged to print on a gMax XT+ for a full size shield. Defiantly use a brim or glue to hold down to bed, as it tends to lift. Pieces were put together with 2 part epoxy and 3/8" wooden dowel rods. Ratchet straps were used to clamp it together. Blend the seams together starting with Bondo brand fiberglass bondo and sanding. A few coats of high build primer with sanding in between. 2 coats of Rust-oleum stone texture finish and 2 coats of same brand matte finish clear. Size ends up about 3 ft tall, 2 ft wide, and 2.5 inches deep. Props to fasteddy516 for model 2677486
Print Settings
Printer:
gMax Xt+
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
5-10%
Filament:
MatterHackers PLA
Various
Notes:
Brim and/or glue to keep from lifting
Long print time
Category: Costume