Patronus Stag — Ring Holder Bust
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stylized stag head bust on a round pedestal — wearable ring/jewelry holder, also a clean desk decoration. 4-tine antlers
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution
A stylized stag bust on a round pedestal — head and shoulders only, antlers raised. Each antler has 4 thick tines angled upward at 50–75° from horizontal so jewelry rings slide down the tine and rest at its base. Built with chunky beams and no fragile spikes; the whole piece prints solidly.
70 mm pedestal, ~120–140 mm tall depending on antler reach
Single solid, flat bottom — prints upright, NO supports
Holds a stack of rings on each tine; smaller rings slide further
Doubles as a desk decoration when not in use
Print notes:
0.2 mm layer, 15–20 % infill is plenty
Silk PLA looks great on the antlers (the photo is silk metallic blue)
Light stringing between antler tines is normal — quick wipe with a hot-air gun cleans it up