AS5600 angle burn assistant
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of grundmann's AS5600 enclosure, modified to help with programming AS5600 without SMT programmer.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 121
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model will allow you to burn an angle into your AS5600 without the use of a programmer, as per Option B in this video:
For 50° angle, insert two short pieces of any 1.75mm filament into holes in the top of the housing, and use them as limits. Make sure the north pole of the magnet is pointed towards the pointed end of the knob. You'll need to eyeball other angles -- err on a side of caution and set the angle slightly too large
You will need two M3 bolts (or ideally thread forming screws) and one 608 bearing.