HC-SR04 wallmount - casted
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D-printed wall-mount shell for HC-SR04, designed to be filled with acrylic for protection.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 22
- Makes
- 0
- Views
- 121
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
Assembly Instructions
This enclosure consists of three 3D-printed parts designed to encapsulate an HC-SR04 ultrasonic sensor in acrylic casting resin for improved durability and water resistance.
Parts
Part A — Baseplate
Part B — Front plate
Part C — Back plate
HC-SR04 ultrasonic sensor
CA glue (cyanoacrylate adhesive)
Acrylic casting resin
Assembly Steps
Insert the HC-SR04
Place the HC-SR04 module into the matching slot in the baseplate (Part A).
Ensure the sensor sits flush and the transducers align correctly with the front opening.
Attach the Front Plate
Position the front plate (Part B) onto the baseplate.
Fix it in place using small amounts of CA glue along the contact edges.
Allow the adhesive to fully cure before proceeding.
Install the Back Plate
Feed the sensor wires through the opening in the back plate (Part C).
Carefully position the back plate onto the enclosure.
Glue it into place using CA glue.
Seal the Enclosure
Apply additional CA glue along all seams and joints.
Ensure all gaps are sealed to improve water resistance and prevent resin leakage.
Fill with Acrylic Resin
Prepare the acrylic casting resin according to the manufacturer’s instructions.
Slowly fill the enclosure to avoid trapping air bubbles.
Allow the resin to fully cure before use.
Done and installed.
