1 / 6
Argus C3 Flash Plug
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
DIY connector to make flash-sync cables for the Argus C3 "Brick" cameras
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 5
- Makes
- 0
- Views
- 36
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Best printed with <20% infill in the vertical orientation.
Non Printed Parts:
- 2x M3x20 screws
- 2x Spade Connectors (I used 20AWG because I had them on-hand)
- 2x M3 Washers
- 2-Conductor wire
See the attached photo for how it all goes together. The screws should thread themselves into the plastic print, if not then change the CAD file to account for your printer's tolerances. Bend the prongs of the spade connectors to 90 degrees so they both fit in the housing.