Moose Bridge Mechanical Pool Cue Bridge (3 sizes)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A stable mechanical support for the cue stick, shaped a little like a moose head, with 9 positions for your cue.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 46
- Makes
- 0
- Views
- 148
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Indoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A stable mechanical support for the cue stick, shaped a little like a moose head, with 9 positions for your cue. It's about 4" wide, has an opening that is just a little over a half inch diameter for the cue you use to support it. You can cut an old cue stick off, to make a permanent bridge cue, or leave the device as an accessory that can slide onto a cue. This model is a first go at it, and lacks any interior taper so it might mar the finish of a nice cue. Wait for an improved model with a taper or put some tape or something on your cue to protect the finish.
This is a first try at this model. I am going to make the hole for the cue stick smaller, at least as an alternate model, so that the bridge mounts closer to the tip. If you want to adjust the distance yourself, you can add a wrap of tape or two.
So far trhee versions uploaded, one with 0.48” diameter opening and one with 0.50” opening and one with a slighly smaller yet opening at 12.5 mm. Please leave me comments or messages about what is a good diameter to fit on your cues. I’m cutting down old cues to make my bridges, but you can slide these on and off of any cue.