M12 Bolt (STRONG) - 12mm x 63mm Bolt - 2 Piece
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
M12 Bolt (STRONG) - 12mm x 63mm bolt and head for aesthetic 3d print applications.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 37
- Makes
- 0
- Views
- 65
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Creative Commons — Public Domain
This is a 3D printable two-piece bolt designed around an ISO metric M12 x 1.75 thread. The finished bolt measures approximately 12mm diameter x 63mm long and is intended to be printed in a stronger horizontal orientation rather than vertically.
Unlike a standard one-piece vertical print, this bolt is split into two pieces so the main threaded shaft can be printed laying flat. This helps improve strength along the length of the bolt by reducing the risk of layer separation under load. The separate bolt head piece allows the part to maintain the look and function of a traditional bolt while still taking advantage of the stronger print orientation.
The end of the bolt includes a notched torque feature designed to allow the bolt to be tightened with pliers. This is useful because it helps avoid damaging the printed bolt head with a socket, especially if the bolt is snug or being used in a test-fit application.
Features
ISO metric M12 x 1.75 thread
Approximate finished size: 12mm x 63mm
Two-piece design
Designed for horizontal printing for improved strength
Separate bolt head piece
Notched end for tightening with pliers
Helps prevent damage to the printed bolt head from socket use
Useful for mockups, prototypes, display models, light-duty fastening, cosplay/prop work, and test-fit assemblies
Printing Notes
For best results, print the threaded shaft horizontally with the threads facing upward/sideways as cleanly as your slicer allows. Supports may be needed depending on your printer, layer height, and orientation.
Recommended settings:
Material: PLA, PETG, ABS, ASA, or nylon depending on use
Layer height: 0.12mm–0.20mm for cleaner threads
Infill: 75%–100% Recommended
Supports: As needed
Print orientation: Horizontal for the bolt shaft
Test fit before final use
PETG, ASA, or nylon are recommended if you need more toughness than standard PLA.
Important Note:
This is a 3D printed plastic bolt and should not be used for structural, safety-critical, automotive, load-bearing, or high-temperature applications. It is intended for prototyping, display, light-duty use, and printed assemblies where failure would not create a safety issue.
