Stiffener for IKEA PAX KOMPLEMENT drawer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stiffener to prevent sagging of bottom plate of drawer.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 95
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution
The bottom plate of your drawer sags because the back panel of the drawer was not stiff enough and the bottom plate slipped past the mounting groove? This stiffener might help you.
Required additional parts:
1x Threaded rod M8 (I cut it to 56,7cm, you may check your drawer length)
8x M8 nuts (2 per part)
2x I would use at least two washers for the sides that take the biggest force (I used washers with diameter of about 15mm to fit the space of about 17mm on the side part)
4x Wood screws to bolt the side parts to the drawer frame (I used TX20 3.5mm x 40mm screws)
Instructions:
Print the part (duh)
Collect additional hardware and cut threaded rod to length
Loosely assemble the four 3D printed parts on the threaded rod
Ideally remove the drawer from the closet and turn it upside down
Place the side parts on the bottom of the drawer on the middle of the front and back panels
Pre-drill hole smaller than the screw you are using
Screw in the wood screws on the side parts
Tighten the M8 nuts
Put the drawer back into the closet
Add the front cover