Glass Stop for Stained Glass on Waffle Boards
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a two piece Glass Stop (Similar to SuperStop by a Stained Glass company) for use on 1/2 inch waffle board.
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 13
- Makes
- 0
- Views
- 93
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Standard Digital File License
This is a two piece Glass Stop (Similar to SuperStop by one of the Stained Glass companies) for use on 1/2 inch waffle board. It holds the glass in place while you cut the glass either by hand or using a cutting system. These were way too expensive for what they are from the glass company and I needed several of them so I just designed and built my own. When printing the Outer piece. Print it on its end with no supports but you will likely have to use a brim since the edge doesn't give you much room to adhere to the bed. Print the Inner piece laying flat with the square cog pointing upward with no supports. You will also need to purchase a 5mm rivet nut and a 5mm thumb screw. These can be had on Amazon in small multi-pacs or your local hardware store if you only want to purchase one of each (probably close to the same cost as an Amazon multi-pack) No rivet insertion tool needed. Just push the rivet nut in thru from the square cog side, slide the Inner in the Outer (dog ears on the Inner to aid in alignment) then screw in the thumbscrew from the top. When attached to the waffleboard the Outer slides in and out to give you maximum flexibility.