Marble Orb - Toy/Fidget (with or without key ring)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Marble run packed into orb. Designed for 10mm marbles.
- Rating
- 0 / 5
- Likes
- 42
- Downloads
- 94
- Makes
- 0
- Views
- 573
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Introduction
I wrapped a marble run along an orb. That's it. Tested on my friends - they said it's fun and addictive. Perfect for fidgeting :D No one was harmed during testing.
Designed for 10mm steel marbles.
Recommended print settings:
Setting | Value |
|---|---|
Material | Suitable for printing toys (I used PET-G and PLA) |
Nozzle | 0.4 |
Layer height | Max. 0.2mm |
Walls | 3 |
Infill | 20% rectangular |
Support | Tree support (it's easier to peel off) |
Brim | Depending on bed adhesion |
After printing, make sure that steel balls fit and don't fall from the groove. The connector is a little bit tricky to print. I recommend printing at 45 degrees - the STL is oriented as suggested.
Assembly
Assembly is really simple. Print two halves and connector, then put it together according to drawing below. Orientation doesn't matter.
Notice for parents
There is a choking hazard due to 10mm balls inside. If you are worried about this, you can glue the two halves together.
Also - it makes noise. It has both upsides and downsides. Proceed with caution.