Battery powered tabletop decoration lamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This lamp makes a nice decoration
- Rating
- 5 / 5
- Likes
- 19
- Downloads
- 63
- Makes
- 0
- Views
- 798
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I've used a dark grey PLA (basicfil) for the colored parts and a transparent PLA for the diffusor. I've set the infill to 100% for the diffusor.
I might print one with wood filament.
I'd love to see a pic of your print! :)
Here's the list of components you need beside the printed case:
- 8 LEDs warm white (3528, I got some pre-wired; saves a lot of hassle https://www.ebay.de/itm/304198347267)
- 3 batteries (AA)
- 1 resistor (12 Ohm)
- 1 battery holder
- 1 locking switch ((https://www.ebay.de/itm/174133295166 ; "rastend"; "3-9V")
- 10 Screws (3x16mm; 4 for the battery compartment, 4 for the top, 2 to fix the diffusor to the shaft)
- a few wires
If you want to be on the safe side, you should print the shaft with 100% infill. If you don't mind the hassle and save some material you can use a support blocker in cura and have 100% infill only around the passage from the shaft to the battery compartment.
Enjoy!