Iridescent Mushrooms Bookmark Set

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

In the style and tones to the glow series: two luminous bookmarks of mushrooms - one on land and the other under the sea, one a part of a colony and the other in solitude, both beautiful and magical. 

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Purple Transmission Distance: 3.6

PLA BambuLab Basic Magenta Transmission Distance: 3

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 4 unique filaments 

Swap Instructions:

Start with Black

At layer (0.96mm) swap to Purple

At layer (1.20mm) swap to Magenta

At layer (1.52mm) swap to Jade White for the rest. 

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away. More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections