Spring Time in Totoro Forest Bookmark

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

Bring a little Studio Ghibli magic to your reading list. Featuring a textured, multi-layered design, it captures a serene moment of Totoro finding shelter under his signature black umbrella amidst a breathtaking canopy of cherry blossoms 📖🌸. This Totoro bookmark is officially my favorite way to keep my place. The layer textures on the cherry blossoms turned out even better than I hoped. 

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm 

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Beige Transmission Distance: 6 (White can be used)

PLA BambuLab Basic Mistletoe Green Transmission Distance: 1.1

PLA BambuLab Basic Red Transmission Distance: 4

This print uses 4 unique filaments 

Swap Instructions:

Start with Black

At layer (0.72mm) swap to Beige (White can be used)

At layer (1.04mm) swap to Mistletoe Green

At layer (1.2mm) swap to Red

At layer (1.52mm) swap to Beige for the rest. 

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. 

Stringing may occur with Hueforge, just use a lighter to whisk them away.  

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections