1 / 2
Adapter Reduzierstück G1 Innengewinde auf G3/4 Aussengewinde, Adapter: G1 female thread to G3/4 male thread — image 1
1 / 2

Adapter Reduzierstück G1 Innengewinde auf G3/4 Aussengewinde, Adapter: G1 female thread to G3/4 male thread

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Adapter Reduzierstück G1 Innengewinde auf G3/4 Aussengewinde, Adapter: G1 female thread to G3/4 male thread

Rating
0 / 5
Likes
3
Downloads
47
Makes
0
Views
161
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Dieser Adapter für ein G1 Innengewinde auf G3/4 Aussengewinde wird beispielsweise benötigt um ein SonOff Zigbee Wasserventil an einem Aussenwasserhahn zu befestigen.

Bitte beachten, es muss wegen Dichtigkeit mit verstärkem Perimeter gedruckt werden; ich habe 10 genommen. Für den Druck sind Stützstrukturen erforderlich, am besten Baumstrukturen und nur auf dem Druckbett. Gedruckt wurde auf einem Prusa Core One mit ASA, PETG ist wegen des Ausseneinsatzes nur bedingt zu empfehlen, PLA sollte man hier besser nicht nutzen. Die Fusion360 Quelldatei habe ich zwecks Remixen etc beigefügt.

Update: Je nach Einsatzgebiet würde ich empfehlen es besser mit Polycarbonat zu drucken. Bei mir sind inzwischen zwei Anschlüsse horizontal abgerissen, die Schichthaftung von ASA scheint nicht besonders gut zu sein. Gedruckt wurde auf einem Prusa Core One+ mit Sunlu Polycarbonat Filament, als Profil habe ich Prusament PC Blend benutzt.


This adapter, which converts a G1 female thread to a G3/4 male thread, is needed, for example, to attach a SonOff Zigbee water valve to an outdoor faucet.

Please note: To ensure a tight seal, it must be printed with a reinforced perimeter; I used a value of 10. Support structures are required for printing, preferably tree structures and only on the print bed. It was printed on a Prusa Core One using ASA; PETG is only recommended to a limited extent due to outdoor use, and PLA should not be used here. I have included the Fusion360 source file for remixing etc.

Update: Depending on the application, I would recommend printing it with polycarbonate instead. Two of my connectors have since snapped off horizontally; the layer adhesion of ASA doesn't seem to be particularly good. I printed it on a Prusa Core One+ using Sunlu polycarbonate filament, and I used the Prusament PC Blend profile.

Tags