1 / 16
The Master Sword from The Legend of Zelda BotW — image 1
1 / 16

The Master Sword from The Legend of Zelda BotW

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A small version of The Master Sword from The Legend of Zelda Breath of the Wild.

Rating
4 / 5
Likes
72
Downloads
196
Makes
2
Views
2,601
Reviews
1

Updated at source:

Model information

Category
Props
License
Creative Commons — Attribution — Noncommercial — Share Alike

Created as a small version of The Master Sword from The Legend of Zelda Breath of the Wild. Modeled in Fusion 360 after the artwork version found at Gamepedias Zelda Wiki.

When printed, the sword is about 75 cm (~30 inches) long.

The model is cut into pieces to fit my FlashForge Adventurer 3 and its 150x150x150 print area. That means the blade is cut into four, and the handle is cut into three parts to remove as much need for supports as possible.

There are two versions of the handle shaft – with and without the wrap. I was going to paint the wrap green, but decided against it in the end. So I should have gone with the version without the wrap.

Quite a lot of sanding was done to finish this one, but I could have done even more. Especially where the blade parts are joined, and on the ends of the handle guard piece. Primed with a plastic primer, painted with basic spray paint and finished with a glossy spray. All of the cheapest kind.

The diamond parts might be a better fit if printed a per cent or two smaller, as it's a really tight fit.

Printed in basic PLA (instore brand of ClasOhlson) on a FlashForge Adventurer 3. Used rafts for the blade parts (to sleep better at night, don't know if it's really necessary). And I used supports and a skirt for the handle guard.

Tags