Automatic cat feeder splitter (for "WOPET Automatic Cat Feeder" & similar)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.58 – €3.16 net (excluding VAT)
For file: Foot_0.2mm_PLA_MINI_2h46m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.87 excluding VAT (range midpoint).
- Weight reported by the author
- 38 g
- Print time reported by the author
- 2.77 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Why pay more for a feeder than comes with one when you can print one for much cheaper?
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 197
- Makes
- 0
- Views
- 2,351
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Printing
The feet can print as-is with no raft or supports.
The splitter will need supports at the tips and under the mounting interface cavity. I have included a print file for the Prusa Mini that shows where these are.
Installation
You'll need to either:
a) Set the feeder on something roughly 35mm above the surface where the bowls are sitting
b) Print 4 of the foot design (which conveniently lift the feeder by 35mm) from this page and hot-glue them onto the 4 corners of your feeder
Then snap the splitter itself into the "accessory connector" (where the bowl that comes with the feeder is normally attached) and put two bowls in front of it.
Customization
I designed both of these parts with OnShape, and you are welcome to view and edit the CAD files.