PC Case Zalman T3 Plus Replacement Side Panel for Travel

I needed a 404mm long x 309mm wide x 3mm thick (and 4mm thick) side panel to replace the glass side panel on my Zalman T3 Plus PC Case since glass doesn't travel well and may break in transit.  I needed 4 pieces with tab in slot and one with dovetail joints since I have a X1C and it was too big for the print bed.  Use Epoxy to join the 4 panels you decide to use (slot in tab or dovetail), not superglue (too brittle).  On the chance this might fit other PC Cases, I did not put in the screw holes.  You can drill them yourself.  I used Transparent Clear PETG and Blue PETG with a solid clear back (2 bottom layers) and set top layers to Zero so the infill (cubic) would show as a design.  This way, one may choose to mount the side panel either side facing out.  As an added bonus, you can print something and glue it to the side panel.  I plan on glueing a Blue Jedi Master design to the outside panel and have lights shine through the cubic infill patterned Transparent Clear PETG for a nice effect.