Dzp MkII Halo ODST Pistol Kit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A kit for the Dart Zone Pro mkII that makes it look like the m6c socom from Halo 3: ODST.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 20
- Makes
- 0
- Views
- 372
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a kit I made for the dart zone pro mkII that makes it look like the m6c socom pistol from Halo 3: ODST. To assemble this kit and install it you will need the following hardware/materials:
1x 5x6mm heat insert
2x m3 hex nuts
3x m3 bolts
2x m3 self tapping screws
superglue
Note that the heat set insert is not required but provides a stronger mechanical connection between the silencer and picatinny rail. It is recommended if you plan on using heavier attachments or just want something stronger. Simply gluing the rail on though is perfectly fine.
Assembly
First cut off the front iron sight on the blaster and sand down the top front section that makes contact with the silencer. Next, remove the orange muzzle piece from the front of the blaster.
Now install the heat set insert into the silencer and install the rail by applying superglue to the bottom of the rail and sticking it on the bottom of the silencer. Then install an m3 screw to hold the rail snuggly.
Next. slide the handguard mount onto the grip of the blaster. You can secure this with super glue or self tapping screws if you predrill holes. Be sure to use as little super glue as possible if you plan on removing the kit in the future for disassembly.
Now secure the bottom of the handguard with an m3 bolt and nut. Rotate the handguard up so it makes contact with the trigger guard. Now using a 3-4mm drill bit, using the hole in the handguard as a guide, drill through the trigger guard. Secure the top of the handguard with another m3 bolt and nut.
Finally, slide the silencer onto the front of the blaster and secure with two self tapping screws. It should fit snuggly onto the blaster. If it is too tight, sand the points on the blaster that make contact with the silencer.
General Notes:
This kit should be compatible with dzp mkIIs that have hand the extended mag mod done to them.
If you plan on painting the blaster like I have, to ensure the top slide slides smoothly, cut away some material from the blaster shell channels where the slide interfaces. Also applying some lubricant helps a lot.
All parts besides the rail will require supports.
Parts should be printed at 4 walls, 50% infill if using pteg. Adjust for other materials accordingly.
The flashlight I used is this one: https://www.amazon.com/dp/B0BTBTQRNX?ref=ppx_yo2ov_dt_b_fed_asin_title&tag=a7b2c4d8e96-20&th=1. The 700 lumen model is plenty bright. If you want a flashlight more accurate to the game, see the original files this kit was remixed from.