FoilDrive MR60 Unit connector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
MR60 housing to connect motor to main foildrive unit (Max/Fusion).
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 1
- Views
- 65
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print in petg-cf or ASA, for motors with attached wires like the flipsky 6384, feed the wires through the 3 holes on top, then solder the MR60 connector, push the MR60 connector into the housing until it rests against the backstop lip. Make sure that the phases are correct and the motor spins correctly. When done, use the back hole of the housing to fill it up with sealant like permatex ultra black gasket maker. Note that the sealant will get into the connectors so have some paper towel ready to scoop it up. Let it cure. Now you have a factory like FD motor cable.
10/9 - added rear cable entry version and a top entry version with 8mm holes