Customizable Can Dispenser (Redbull)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's cheap and stackable can dispenser for standard redbull cans.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 34
- Makes
- 0
- Views
- 310
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
I’ve been looking for a can holder/dispenser for a while that was cheap to print and modular to fulfill my needs. Haven’t found one so i made my own design.
I've created a stackable, low cost redbull cans dispenser. I made my 3 floors high and it's pretty stable, u can propably make it min. 6 floors high but i didn't test it. Each floor can hold about 4 cans, bottom floor can hold 5.
Print info:
REMEMBER TO MIRROR WALLS AND SLIDE
4 wall loops, 3 top/bottom, 30% gyroid infill
Check notes under files for number of each
Assembly:
First of all, connect both Shells for 1st floor with 2 Shell Connectors, then u can add 2 Slide pieces and connect them with Slide Connector. If u want to make dispenser higher, u have to make the same thing as before with walls, align it with the 1st floors holes for Vertical Connectors, when aligned, squeze in the Vertical Connectors in those 4 holes. Also, if u want to use those Front/Back walls, remember to put them before you add another floor as each shell has a blockade at the bottom for those walls.
IMPORTANT:
The design is made with tolerances in mind, but u may need to cut pieces of vertical connectors with a knife to make them fit but not too much as they hold the tower upwards. Squeezing those in with tools might be a good idea.