ColorMix - PeggyPalette - Remix
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.97 – €3.63 net (excluding VAT)
For file: PeggyPalette38_MK4SMMU3_BRYW_0.4n_0.15mm_PLA,PLA,PLA,PLA_MK4SMMU3_3h30m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.30 excluding VAT (range midpoint).
- Weight reported by the author
- 37 g
- Print time reported by the author
- 3.5 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Remix for Prusa Slicer 2.9.6 beta 1 or newer and MK4S with MMU3.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 79
- Makes
- 2
- Views
- 316
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Share Alike
Introduction
This is a PrusaSlicer 2.9.6 beta 1 remix/adaptation of jusdisgi’s PeggyPalette Mini – 38-Color Full Spectrum Tester, prepared for the Original Prusa MK4S with MMU3. The color blends are manually transferred to virtual extruders in Prusa Slicer.
The original model by jusdisgi is a compact and very useful 38-color palette tester for exploring full-spectrum color blending with four filaments. The concept provides a practical way to compare how different filament combinations behave when layered and blended.
Use this model to compare:
BRYW / CMYW-style filament combinations
Alternative four-color sets
Layer-height effects on perceived color
Transparency and opacity differences between filament brands
Purge and transition behavior on the MMU3
Usage
Depending on the filaments chosen, results may vary significantly; therefore, this model is primarily intended as a calibration and comparison object for experimenting with color combinations, layer heights, and material behavior.
The filaments used in the photo of the print are:
B = Prusament PLA Blend Royal Blue
M = Prusament PLA Lipstick Red
Y = Prusament PLA Pineapple Yellow
W = Sunlu PLA+ White
Notes
For this remix, the layer height was set to 0.15 mm. The original model for the Snapmaker U1 by jusdisgi uses 0.1 mm and variable layer height. However, this is problematic to print with the MMU3 due to the wipe tower. Bulges quickly form on the tower, leading to layer ghosting and print head collisions. With multi-extruder systems (XL or INDX), however, 0.1 mm should be possible without any issues. The lower the layer height, the better the color blending!