PreCure Cure White carbon 13 based action figure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An action figure based on the Pretty Cure anime series, made by modifying the carbon 13 type F model by soozafone.
- Rating
- 0 / 5
- Likes
- 59
- Downloads
- 152
- Makes
- 0
- Views
- 1,439
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
notes on printing
Parts with 2x need to be printed twice, and those with 3x need to be printed three times
Parts with "L" in their name indcate that they are only for the left side and need to be flipped in the slicer for the other side
Joints must be printed with abs or petg since they're tougher than pla, the rest of the parts, however can be printed in any filament you like
The "side hair" part can limit head movement if not printed in a flexible material, if you don't have any you can still print it in a rigid material or you can replace it and the "back hair" part with the "back hair complete" part which doesn't have the twostrands going over the shoulders
Print with supports and with the highest quality you can for best results, joints can be printed with lower quality since they are mostly hidden
notes on assembly
For the head you can glue it all together except for the face so you can swap different expressions
If the face plate is painted it might be scratched when put on the head, to avoid it you can heat the slot where it is inserted with a hair drier and then insert it and wiggle it a little. This will loosen the fit while still allowing it to be locked in place when the head is connected to the neck
The shoulder cover thingy should be glued after inserting the clavicle into the shoulder joint. You won't be able to insert it later as it blocks top of the socket
The flat part of the ankle ball should go towards the back of the leg. if it doesn't fit in the leg hole shave the corners a little
The "abs" part is designed to be glued to the skirt piece, other parts that should be glued are the wrist ball to the forearm, the ankle ball to the lower leg, the bow to the chest and the commune to the skirt
For the rest of the build you can follow the guide for the original model that this figure is based on
additional notes
All the faces for this figure are compatible with my Cure Black figure
I hope you like the model, I'm still learning so suggestions are appreciated :)
updates
added missing "ankle ball" file