Backpack MOLLE patch European country flags

Add country flags to your MOLLE / PALS system on your backpack.

This includes

• 2 color horizontal and vertical, for example Ukraine and Poland.

• 3 color horizontal and vertical, like Netherlands, Germany, France, Italy, Estonia, Lithuania, Austria

• Nordic cross 2 color, Denmark, Sweden, Finland

• Nordic cross 3 color, Norway and Iceland

There are a few "weird" ones... Switzerland ofc, Latvia has a small middle band, Spain a thick middle band, Czech Republic has triangles (and already exists on Printables, see below), Portugal is like 1/3 and 2/3 with a very detailed logo, Slovakia and Slovenia needs their logo to not be identical, etc. 

Canadian can be found here by @Garage_Tinkerer (his slanted rear design gave me some nice ideas)

Czech Republic can be found here by @AlanBruska_1309361 (the usage of the chamfers came from there)

UK and US are here to be found.

You need to paint the items in the slicer yourself. Just start out with the entire part in your base color (black in my case), then use the paint bucket to do all the sides. Be sure to also paint the surfaces inside the "gorges", else that will remain black and you probably get color-bleed.

In the example I used the following filaments:

• Black // Sunlu PETG (not Matte, not HS)

• Red // Extrudr PCTG hellfire red

• White // Qidi PETG basic

• Blue // Qidi PETG basic

Let me know if there's any suggestions or (helpful) critisism. 

One thing I already noticed is that the slanted back is pretty rough, might see some drooping if you don't use supports (prints okay  without it). Probably too much overhang, borderline bridging, but it's on the backside, hidden by the MOLLE mesh, will make a note for a v2 down the road.