1 / 4
Soda bottle water sprinkler
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Limited flow soda bottle watering attachment for plants
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 35
- Makes
- 0
- Views
- 203
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Simple soda bottle watering attachment for limited flow and small plants. Self limiting water flow after some time. To continue we have to allow air inside by tilting the bottle vertically up.
May need a rubber washer 1 inch diameter for a tight fit.
PLA 0.2mm layer is the best setting. While slicing no support need to be generated. Simply lay flat the model on the bottom wide surface . Use of brim for print bed adhesion is recommended.